Multiple Evaporator Ice Machines - Manitowoc 820C Serie Manual De Instalación, Operación Y Mantenimiento

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Section 4

MULTIPLE EVAPORATOR ICE MACHINES

A. Remove front evaporator shield
• Remove four quarter-turn connectors.
• Remove splash shield.
B. Remove left and right evaporator top covers
• Remove two thumbscrews from the front of each
evaporator top cover.
• Lift front of cover, pull forward to remove.
C. Remove splash shields
NOTE: Each evaporator has a splash shield that must be
removed - total of four splash shields.
• Grasp the top center of splash shields.
• Lift up and then out.
D. Remove ice thickness probe
• Compress the hinge pin on the top of the ice thickness
probe.
• Pivot the ice thickness probe to disengage one pin then
the other. The ice thickness probe can be cleaned at this
point without complete removal. If complete removal is
desired, disconnect the ice thickness control wiring from
the control board.
E. Remove the water pump assembly
• Disconnect the vinyl distribution tube from both water
pumps.
• Disconnect the water pump and water level probe
electrical connections.
A
C
Part Number: 000013325 Rev 02 6/17
B
E
D
F
• After the wires are disconnected, remove the two
thumbscrews and lift the water pump assembly out of
the ice machine.
• Remove the thumbscrews securing the water pumps (2
each pump) and remove water pumps. Do not immerse
the water pump motor in cleaner or sanitizer solutions.
• Remove the water level probe from the assembly
housing.
F.
Remove the water trough
• Pull forward on the water trough to remove.
G. Remove distribution tubes
NOTE: Each evaporator has a distribution that must be
removed - total of four distribution tubes.
• Thumbscrews for the distribution tube are retained
to prevent loss. Loosen thumbscrews, but do not pull
thumbscrews out of distribution tube.
• Loosen the two outer screws and pull forward on the
distribution tube to release from slip joint.
• Disassemble distribution tube by loosening the two (2)
middle thumbscrews and dividing the distribution tube
into two pieces.
H. Remove ice dampers
NOTE: Each evaporator has an ice damper that must be
removed - total of four ice dampers.
• Grasp ice damper and apply pressure toward the back
mounting bracket.
• Apply pressure to the front mounting bracket with
thumb.
• Pull ice damper downward when the front ice damper
pin disengages.
G
H
Maintenance
43
Tabla de contenido

Solución de problemas

loading

Tabla de contenido