Frost Protection; Removing The Batteries - Kärcher B 95 RS Manual De Instrucciones

 Squeeze the locking hooks.
 Pull off the float.
 Turn the protective turbine strainer in a
counter-clockwise direction.
 Remove protective turbine strainer.
 Rinse dirt off the protective turbine
strainer with water.
 Reattach protective turbine strainer.
 Attach float.
Replacing the vacuum lips
 Remove the vacuum bar.
 Unscrew the star grips.
 Remove the plastic parts.
 Remove the vacuum lips.
 Insert new vacuum lips.
 Insert the plastic parts.
 Screw in and tighten the star grips.
Install cleaning head
 R cleaning head: Unscrew the star han-
dle and remove the lid.
 D cleaning head: Remove the lid of the
cleaning head.
 Place the cleaning head centrally under
the device.
24
 Connect the power cord of the cleaning
head to the appliance (same colours
must meet).
 R cleaning head: Slide the lid in and
tighten the screw.
 D cleaning head: Replace the lid and
lock it.
 Connect the hose couplers on the
cleaning head to the hose on the appli-
ance.
 Insert the tab into the middle of the
cleaning head, between the fork of the
lever.
 Align the lever so that the drilled holes
in the lever and the cleaning head
match.
 Insert the retaining pin through the
drilled holes and swivel the locking
plate downwards so that it snaps into
place.
Mount splash guard
 Select the floor clearance of the spray
guard by turning the adjustment wheel.
Replacing the brush rollers
 Lift the cleaning head.
 Loosen the lock of the wiper flap.
 Swivel the wiping flap out of the way.
9
-
EN
 Loosen the lock of the wiper flap.
 Push the bearing lid down and remove.
 Pull out the brush roller.
 Insert a new brush roller.
 Reattach the bearing lid and the wiper
flap in reverse sequence.
 Repeat process on the opposite side.
Replacing the Disk Brushes
 Lift the cleaning head.
 Press the pedal for changing the brush-
es downward beyond its resistance.
 Pull the disc brush out of the side below
the cleaning head.
 Hold the new disc brush under the
cleaning head, push upward and lock.

Frost protection

In case of danger of frost:
 Empty the fresh and dirt water reser-
voirs.
 Store the appliance in a frost-protected
room.

Removing the batteries

 Open the lock of the battery cover.
 Tilt the battery cover backwards.
 Push the lock of the battery insert to-
wards the left and tilt it downward.
 Pull the battery insert towards the rear.
 Clamp off the minus pole of the battery.
 Clamp off the remaining cables from the
battery.
 Remove the batteries.
 Dispose of the used batteries according
to the local provisions.