Making Settings - Parkside PMB 1100 B2 Traducción Del Manual De Instrucciones Original

Mounting the band saw on the swivel arm
If you plan to operate the appliance using the saw
table , proceed as follows:
♦ Attach the swivel arm
screws supplied in the corresponding holes
of the appliance housing (see fig. E on the
fold-out page).
NOTE
► It is possible that the nuts
tight on delivery. Loosen the nuts
with a 19 mm wrench.
► Tighten the nut
21a
19 mm wrench if the swivel arm
much play.
WARNING!
► The band saw may only be used without
the saw table
steady footing. The workpiece must also be
secured against slipping, for instance on a
workbench.
► Make sure at all times that the power cord
can not get near the saw blade.
► If you want to use the appliance with the
saw table, attach the power cable with the
A
cable holder as shown in the following
diagram:
B
► For any other use, the cable must be routed
using the cable holders
cable can never get into the sawing/working
area or any other hazardous area.
PMB 1100 B2
using the 3 long wing
21a are a little too
a little
21a
from time to time with a
has too
if the user has firm,
A B
so that the

Making settings

Adjusting the handle
♦ To adjust the handle
screw on the handle.
♦ Turn the handle
♦ Retighten the wing screw
Using the vice
♦ Turn the handle on the vice
clamp the workpiece.
♦ Turn the handle on the vice
to unclamp the workpiece.
NOTE
► You can also flip the quick release
in order to adjust the vice
quickly. Fold the quick release
again to fix the vice
the vice handle
Transport restraint
♦ To release the position, pull out the locking
pin so you can lower the band saw.
♦ Swivel the band saw downwards and push in
the locking pin
port the band saw together with the saw table.
Setting the cutting angle (mitre angle)
♦ Undo the cutting angle adjustment
it anticlockwise.
♦ Set the required cutting angle using the angle
A
provided.
♦ Retighten the cutting angle adjustment
turning it clockwise.
, loosen the wing
to the required position.
.
clockwise to
anticlockwise
upwards
15a
setting more
back down
15a
in place. After this, use
to make fine adjustments.
. Now you can easily trans-
by turning
GB │ IE │
by
7 ■