Fault Messages And Fault Elimination; Accessories; Disposal - Weller WD 1 Manual De Uso

WD 1 (M) / WD 1000 (M)
Message/Symptom
Display: "- - -"
Display: "tip"
No display function (display off) No mains supply voltage
All manuals and user guides at all-guides.com
8 WD 1 (M) / WD 1000 (M) care and
maintenance
Dirt and foreign objects accumulated in the join between the heating
element / sensor and the soldering tip or damage to this join may
affect the accuracy of the temperature control.

9 Fault messages and fault elimination

Possible cause
Tool has not been detected
Tool defective
Soldering tip of microtool not
correctly inserted or defective

10 Accessories

005 13 173 99 WMRT Desoldering set (for WD 1M only)
005 27 028 99 WHP 80 Preheater plate
005 29 178 99 WSP 80 Soldering-bit set
005 29 179 99 WMP Soldering-bit set
005 31 185 99 USB Extension module
005 29 188 99 LR 82 Soldering-bit set
005 33 131 99 MPR 80 Soldering-bit set
005 33 133 99 WTA 50 Desoldering set
005 29 190 99 WMRP Soldering set (for WD 1M only)
005 15 161 99 WDH 10T Switching holder WSP 80/WP 80
005 15 162 99 WDH 20T Switching holder for WMP
005 15 125 99 WDC 2 Dry cleaning insert
005 13 825 99 Wool balls for WDC 2
005 87 597 28 Reset connector °C
005 87 597 27 Reset connector °F
Please refer to the operating instructions accompanying the
individual soldering-bit sets for more information on accessories.

11 Disposal

Dispose of replaced equipment parts, filters or old devices in
accordance with the rules and regulations applicable in your country.
Corrective measures
Check connection of tool to
device
Check connected tool
Insert soldering tip again
Replacing defective soldering tip
Turn on mains power switch
Check mains supply voltage
Check device fuse
17-18