Resetting To Factory Settings; Wd 1 (M) / Wd 1000 Care And Maintenance; Fault Messages And Fault Elimination - Weller WD 1000T Manual De Instrucciones

WD 1 (M) / WD 1000
Message/Symptom
Display: "- - -"
Display: "tip"
No display function (display off) No mains supply voltage
PK Elektronik Vertriebs GmbH, E-Mail: [email protected], Internet: www.pkelektronik.com

8 Resetting to factory settings

Resetting the special functions
This function is described under "7.1 Selecting special functions
menu 1", "Resetting the special functions to the factory settings" on
page 10.
Resetting calibration to factory settings
This function is described under "7.2 Selecting special functions
menu 2", "Resetting calibration to factory settings" on page 14.
9 WD 1 (M) / WD 1000 care and
maintenance
Dirt and foreign objects accumulated in the join between the heating
element / sensor and the soldering tip or damage to this join may
affect the accuracy of the temperature control.

10 Fault messages and fault elimination

Possible cause
− Tool has not been detected
− Tool defective
Soldering tip of microtool not
correctly inserted or defective
Corrective measures
− Check connection of tool to
device
− Check connected tool
− Insert soldering tip again
− Replacing defective soldering tip
− Turn on mains power switch
− Check mains supply voltage
− Check device fuse
17-18