Adjusting Angle/Mitre Stop; Switching Machine On/Off; Existing Storage Places; Operation Modes - HOLZMANN MASCHINEN TK255 Instrucciones De Servicio

16.2.4 Adjusting angle/mitre stop

16.2.5 Switching machine ON/OFF

16.2.6 Existing storage places

16.3 Operation modes

Sawing straight cuts
– Position the rip fence to the desired cutting width.
- Place the workpiece on the saw table in front of the saw blade cover.
- Adjust the saw blade height so that the upper teeth are approx. 3-6 mm above the workpiece.
- Switch on the machine
- Saw through the workpiece at a steady feed rate. If you apply too much pressure, the saw
blade tips may overheat and the workpiece may be damaged.
- Switch off the machine when you have finished sawing and wait until the saw blade has come
to a complete stop..
HOLZMANN MASCHINEN GmbH
 Release the angle stop lock (2).
 Set the desired angle
 Lock the angle stop (2) again.
 The position of the fence can be adjusted by
loosening the screw (2) and sliding it.
 ATTENTION: Check the distance to the saw blade and
readjust if necessary.
Switch the machine ON:
Press the ON button (I)
Switch the machine OFF:
Press the ON-OFF switch (0)
 A spare saw blade is stored with the spare saw blade
attachment (1).
 The rip fence is stored in slot 2
 The push stick is stored in slot 3.
 The power cord is stored in the power cord holder
(4).
 The tool is stored in the tool compartment
 The angle stop is stored in the slot (5)
www.holzmann-maschinen.at
OPERATION
35
TK255