Stihl MS 200 T Manual De Instrucciones página 30

English
As soon as the engine runs
1
2
N Blip the throttle trigger (2). The
Master Control lever (1) moves to
the run position F and the engine
settles down to idling speed.
N Pull the hand guard toward the top
handle.
The chain brake is now disengaged –
your saw is ready for operation.
28
Always disengage chain brake
before accelerating the engine.
High revs with the chain brake
engaged (chain locked) will
quickly damage the clutch and
chain brake.
At very low outside temperatures:
N Allow engine to warm up at part
throttle.
N Change over to winter operation if
necessary – see "Winter
Operation".
Shut off the engine
N Move the Master Control lever to the
stop position (0).
If the engine does not start
If you did not move the Master Control
lever to the starting throttle position (n)
quickly enough after the engine began to
fire, the combustion chamber is flooded.
N Move the Master Control lever to the
stop position (0).
N Remove the spark plug – see
"Spark Plug".
N Dry the spark plug.
N Crank the engine several times with
the starter to clear the combustion
chamber.
N
Refit the spark plug – see "Spark
Plug".
N Set Master Control lever to the
starting throttle position (n) – even
if the engine is cold.
N Now start the engine.
If fuel tank has been run completely
dry and then refueled
N Pull the starter rope several times to
prime the fuel system.
N Now start the engine.
MS 200 T