Stihl MS 200 T Manual De Instrucciones página 29

2
4
3
N Push the hand guard (1) forward –
the chain is locked.
N Press down the throttle trigger
lockout (2) and pull the throttle
trigger (3) at the same time. Hold
both levers in that position and set
Master Control lever (4) to:
Choke shutter closed (l)
– If the engine is cold (also use this
position if the engine stopped when
you opened the throttle after
starting)
Starting throttle position (n)
– If the engine is warm, i.e. if it has
been running for about one minute.
MS 200 T
Cranking
1
N Pull the starter grip slowly with your
left hand until you feel it engage –
and then give it a brisk strong pull
and push down the top handle at the
same time. Do not pull out the
starter rope to full length – it might
otherwise break. Do not let the
starter grip snap back. Guide it
slowly back into the housing so that
the starter rope can rewind properly.
Machines without additional manual fuel
pump: If the engine is new or after a long
out-of-service period, it may be
necessary to pull the starter rope several
times to prime the fuel system.
When the engine begins to fire:
1
N Set the Master Control lever (1) to
the starting throttle position ( n ).
N
Hold and start your saw as
described.
English
27