Configuration - GYS POT COMBI ARCPULL Manual De Instrucciones

Operating manual

CONFIGURATION

Configuration
> Pregaz > 0.2s
Postgaz 0.2s
Langue FR
Reset machine
Info
Settings range
Pre-Gas Then no gas from 0.2 - 3 s For gas-shielded welding, it is recommended to have a Pre-Gas of at
Post-Gas Then no gas from 0.2 - 3s
Language FR, EN, DE, NL, ES, IT, RU
Press the return button
Machine Reset
Reset machine
: 3sec
pour valider
Info machine
Soft géné V1.0
Hard géné V2.0
Soft pistolet V1.0
Hard pistolet V2.0
UPDATE VIA THE USB PORT
In order to benefit from new synergies and improved software, the user can update the aluminium section using the USB
port on the front panel. To do this, contact the GYS after-sales service team and follow the procedure.
TOOLS FOR THE WELDING GUN
Included as an optional extra, welding attachments to aluminium/steel is possible with the accesso-
ries listed at the end of the manual (threaded studs and insulating nails, etc.).
30
Translation of the original
instructions
Press the G+ and G- keys to move the left cursor (Pre-Gas, Post-Gas, language, ma-
chine reset and data).
When the Pre-gas, Post-gas or language options are highlighted, press the D+ and D-
keys to change their value.
Comments
least 0.2 s with a flow rate between 10 - 12 l/min.
When welding under a gas shield, it is recommended to have Post-Gas
limit of at least 0.2 s.
to go back to the main menu.
When 'Machine Reset' is selected from the settings menu, pressing Menu/Enter
bring up the machine's reset submenu.
Hold down the Menu/Enter button
Press the return button
device.
Information panel
The information panel shows the device's software and hardware part numbers and that of
the welding gun (if connected).
for three seconds to confirm resetting the device.
to go back to the settings menu and to cancel resetting the
GYSPOT COMBI ARCPULL
will