Tabla de contenido
3
INSERT THE NUT PLATES.
Insert 2 nut plates into the cut outs at each side of the Platform and slide them over as shown.
4
ATTACH THE AWNING.
LOW POSITION
POSITION BASSE
POSICIÓN BAJA
Instruction #1036150A - page 3 of 11
Align the nut plates you inserted in the previous step with
the brackets. TIP: Use the hex wrench to adjust the position
of the nut plates as necessary. Using the 5 mm hex wrench,
secure each bracket with 2 thin washers and 2 screws. Before
tightening completely, be sure the awning is centered with the
Platform and the set of brackets are centered with the awning.
Tighten the screws and the bolts completely to 9 Nm ±1.
LOW POSITION
POSITION BASSE
POSICIÓN BAJA
HIGH POSITION
POSITION HAUTE
POSICIÓN ALTA
Tabla de contenido
