Part Names Of The Projector; Attaching The Lens Cap - NEC HT1100 Manual Del Usuario

Part Names of the Projector

Remote Sensor (See page E-10)
Ventilation (outlet)
Heated air is exhausted from here
Adjustable Tilt Foot Lever (See page E-19)
Adjustable Tilt Foot (See page E-19)
* This security slot supports the MicroSaver
trademarked and owned by Kensington Microware Inc.
Remote Sensor (See page E-10)
AC Input
Connect the supplied power cable's three-pin plug here, and plug the
other end into an active wall outlet. (See page E-17)

Attaching the lens cap

To attach the lens cap to the bottom with the supplied string and rivet:
1. Thread the string through the
hole on the lens cap and then
tie a knot in the string.
All manuals and user guides at all-guides.com
Focus Ring (See page E-20)
Lens Cap
®
Security System. MicroSaver
PC Card Eject Button
PC Card Slot
VID EO VID EO
S-V IDE S-V IDE
PC CO O O
COM PON
NT RO ENT
L RG B/D RG B/D
VID EO VI VI
AU DIO AU DIO
IN S-
VID EO IN IN
SC TR
IN IG GE R
Y
Cb /Pb
Cr/ Pr
CO MP
UT ER
Rear Foot
E-6
Controls (See page E-7)
Ventilation (inlet)
Built-in Security Slot (
Zoom Lever (See page E-20)
Carrying Handle
Lens
Iris Lever (See page E-20)
®
is a registered trademark of Kensington Microware Inc. The logo is
Stereo Speaker (2W)
Lamp cover screw
IN
DV I-D
IN
Rear Foot
Rotate to make the projector level. (See page E-20)
Main Power Switch
When you plug the supplied power cable into an active wall outlet and
turn on the Main Power switch, the POWER indicator turns orange and
the projector is in standby mode. (See page E-18)
2. Use the rivet to attach the
string to the bottom of the
projector.
)*
Lamp cover (See page E-43)
Ventilation (outlet)
Heated air is exhausted from here