When Viewing A Dvi Digital Signal; Connecting The Supplied Power Cable - NEC HT1100 Manual Del Usuario

When Viewing a DVI Digital Signal:

To project a DVI digital signal, be sure to connect the PC and the projec-
tor using a DVI-D signal cable (not supplied) before turning on your PC
or projector. Turn on the projector first and select DVI (DIGITAL) from
the source menu before turning on your PC.
Failure to do so may not activate the digital output of the graphics card
resulting in no picture being displayed. Should this happen, restart your PC.
Do not disconnect the DVI-D signal cable while the projector is running. If
the signal cable has been disconnected and then re-connected, an im-
age may not be correctly displayed. Should this happen, restart your PC.

Connecting the Supplied Power Cable

Connect the supplied power cable to the projector.
First connect the supplied power cable's three-pin plug to the AC IN of
the projector, and then connect the other plug of the supplied power
cable in the wall outlet.
All manuals and user guides at all-guides.com
AUDIO IN
VIDEO VIDEO S-VIDEO S-VIDEO
PC CONTROL VIDEO IN S-VIDEO IN
Y
Audio cable (not supplied)
PHONE
E-17
DVI-D IN
COMPONENT RGB/DVI RGB/DVI AUDIO IN AUDIO IN SC TRIGGER
DVI-D IN
Cb/Pb Cr/Pr
COMPUTER IN
DVI-D Signal cable (not supplied)
NOTE:
• Use the DVI-D cable compliant with DDWG (Digital Display Working Group)
DVI (Digital Visual Interface) revision 1.0 standard. The DVI-D cable should
be within 5 m (196") long.
• See page E-49 for DVI digital signals the DVI (DIGITAL) connector supports.
VID EO VID EO
S-V IDE S-V IDE
PC CO O O
COM PON
NT RO L
ENT
RG B/D RG B/D
VID EO VI VI
IN AU DIO AU DIO
S- VID EO IN IN
SC TR
IN
IG GE R
Y
Cb /Pb
Cr/ Pr
CO MP
UT ER
IN
DV I-D
IN