Connecting Your Pc Or Macintosh Computer; To Connect Scart Output (Rgb) - NEC HT1100 Manual Del Usuario

Connecting Your PC or Macintosh Computer

Audio cable (not supplied)
NOTE: For older Macintosh, use
a commercially available pin
adapter (not supplied) to con-
nect to your Mac's video port.
IBM VGA or Compatibles (Desktop type)
or Macintosh (Desktop type)
Connecting your PC or Macintosh computer to your projector will en-
able you to project your computer's screen image for an impressive pre-
sentation.
To connect to a PC or Macintosh, simply:
1. Turn off the power to your projector and computer.
2. Use the supplied signal cable to connect your PC or Macintosh to the
projector.
3. Turn on the projector and the computer.
4. If the projector goes blank after a period of inactivity, it may be caused
by a screen saver installed on the computer you've connected to the
projector.
For European model only

To connect SCART output (RGB)

Before connections: The supplied SCART adapter (ADP-SC1) and a
commercially available SCART cable are required for this connection.
NOTE: Audio signal is not available for this connection.
Video equipment
such as DVD player
Commercially available
SCART cable
All manuals and user guides at all-guides.com
AUDIO IN
VIDEO VIDEO S-VIDEO S-VIDEO COMPONENT RGB/DVI RGB/DVI AUDIO IN AUDIO IN SG TRIGGER
PC CONTROL VIDEO IN S-VIDEO IN Y Cb/Pb Cr/Pr
COMPUTER IN
PHONE
Projector
To COMPUTER IN
SCART adapter
ADP-SC1 (supplied)
E-16
COMPUTER
DVI-D IN
RGB signal cable (supplied)
To mini D-Sub 15-pin connector on the projector. It is recommended
that you use a commercially available distribution amplifier if con-
necting a signal cable longer than the supplied one.
IBM VGA or Compatibles (Notebook type)
or Macintosh (Notebook type)
NOTE: The HT1100 is not compatible with video decoded outputs of NEC ISS-
6020 and ISS-6010.
NOTE: An image may not be displayed correctly when a Video or S-Video source
is played back via a commercially available scan converter.
This is because the projector will process a video signal as a computer signal at
the default setting. In that case, do the following.
* When noise appears on the sides of the screen:
Use the Overscan feature to display the image correctly.
Be sure to change the Overscan to 0% before pressing the AUTO ADJ or
AUTO ADJUST button. Unless otherwise an image may be displayed with its
sides cut off.
1. Turn off the power to the projector and your video equipment.
2. Use the supplied SCART adapter and a commercially available
SCART cable to connect the COMPUTER input of your projector and
a SCART output (COMPUTER) of your video equipment.
3. Turn on the power to the projector and your video equipment.
4. Use the COMPUTER button on the remote control to select the COM-
PUTER input.
5. Press the MENU button on the remote control to display the menu.
6. From the Advanced menu, select [Setup] → [Page 2] → [Signal Se-
lect] → [Computer] → [Scart].
SCART is a standard European audio-visual connector for TVs, VCRs
and DVD players. It is also referred to as Euro-connector.
PHONE