Installation | Disassembly | Connections - Blaupunkt 400 Serie Instrucciones De Uso

18. Installation | Disassembly | Connections

Installation guide
Install the unit only if you have experience
installing car radios and are familiar with the
vehicle's electrical system. Observe the
information marked on the unit connections. Connect the
device using the appropriate adapters; ensure that all wires
transfer the correct signals or voltages. The plugs in the vehicle
must not be connected directly to the car radio.
The installation of the radio must not interfere with or prevent
the activation of airbags and other safety devices and/or
controls.
Disconnect the vehicle battery (negative terminal, ground)
before installing the device, as doing otherwise may cause
malfunctions or damage to the device or the vehicle
electronics.
Observe the vehicle manufacturer's safety instructions (airbag,
alarm system, on-board computer, immobiliser, etc.).
Optional and dedicated connection adapters and/or mounting
accessories such as mounting frames, covers, etc. may be
required depending on the vehicle in which the radio is
installed.
Installation errors can result in damage to the unit or the
vehicle electronics.
The radio housing gets hot during operation; make sure that
no wires come in contact with the housing.
If you need help installing the unit, consult a car Hi-Fi
specialist.
To remove the radio, loosen the side covers (see "CONTROLS –
DEVICE"); they can be lifted from the side with a fingernail.
Insert the release handles into the holes until they snap into
place. Then, carefully pull the radio out of the mounting
socket. Make sure not to damage any wires.