Tabla de contenido
To get the most out of the many functions of this machine and operate it in safety, it is necessary to
use this machine correctly. Please read this instruction manual carefully before use. We hope you will
enjoy the use of your machine for a long time. Please remember to keep this manual in a safe place.
1. Observe the basic safety measures, including, but not limited to the following ones, whenever you
use the machine.
2. Read all the instructions, including, but not limited to this instruction manual before you use the
machine. In addition, keep this instruction manual so that you may read it all anytime when
necessary.
3. Use the machine after it has been ascertained that conforms with safety rules/standards valid in
your Country.
4. All safety devices must be in position when the machine is ready for work or in operation. The
operation without the specified safety devices is not allowed.
5. This machine shall be operated by appropriately-trained operators.
6. For your personal protection, we recommend that you wear safety glasses.
7. For the following, turn off the power switch or disconnect the power plug of the machine from the
receptacle,
7.1. For threading needle(s), looper, spreader, etc. And replacing bobbin.
7.2. For replacing part(s) of needle, presser foot, throat plate, looper, spreader, feed dog,
needle guard, folder, cloth guide etc.
7.3. For repair work.
7.4. When leaving the working place or when the working place is unattended.
8. If you should allow oil, grease, etc. used with the machine and devices to come in contact with your
eyes or skin or swallow any of such liquid by mistake, immediately wash the contacted areas and
consult a medical doctor.
9. Tampering with the live parts and devices, regardless of whether the machine is powered, is
prohibited.
10. Repair, remodeling and adjustment works must only be done by appropriately trained
technicians or specially skilled personnel. Only spare parts designated by can be used for
repairs
11. General maintenance and inspection works have to be done by appropriately trained
personnel.
12. Repair and maintenance works of electrical components shall be conducted by qualified
electric technicians or under the audit and guidance of specially skilled personnel. Whenever
you find a failure of any of electrical components, immediately stop the machine.
13. Before making repair and maintenance works on the machine equipped with pneumatic parts such
as an air cylinder, the air compressor has to be detached from the machine and the compressed air
supply has to be cut off. Existing residual air pressure alter disconnecting the air compressor from
the machine has to be expelled. Exceptions to this are only adjustments and performance checks
done by appropriately trained technicians or specially skilled personnel.
14. Periodically clean the machine throughout the period of use.
15. Grounding the machine is always necessary for the normal operation of the machine. The machine
has to be operated in an environment that is free from strong noise sources such as high-frequency
welder.
16. An appropriate power plug has to be attached to the machine by electric technicians. Power plug
IMPORTANT SAFETY INSTRUCTIONS
i
Tabla de contenido
