Maintenance; Troubleshooting - Becken BBIC2341 Manual De Instrucciones

Frigorífico combi integrable
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

• Milk bottles: these should have a cap and should be stored in the shelves on the door.
• Bananas, potatoes, onions and garlic must not be kept in the fridge unless packaged.
Energy saving
• Don't put hot food in the appliance;
• Don't pack food items close together as this prevents air circulating;
• Make sure food does not touch the back of the compartment(s);
• If the electricity goes off, don't open the door(s);
• Don't open the door(s) frequently;
• Don't keep the door(s) open for too long;
• Don't set the thermostat to exceedingly cold temperatures;
• Some accessories, such as drawers, can be removed to get larger storage
volume and lower energy consumption.

2.3. Maintenance

For hygienic reasons, the appliance's interior, including interior accessories, should be
cleaned regularly.
Caution! The appliance must not be connected to the mains during cleaning. Danger
of electrical shock! Before cleaning, switch the appliance off and unplug from the
mains, or switch off the circuit breaker, or remove the fuse. Never clean the appliance
with a steam cleaner. Moisture may accumulate in electrical components resulting in
danger of electrical shock! Hot vapor can cause damage to plastic parts. The appliance
must be dry before it is put back into service.
Important! Ethereal oils and organic solvents can attack plastic parts, e.g. lemon juice
or the juice from orange peel, butyric acid, or cleansers that contain acetic acid.
• Do not allow such substances to come into contact with appliance parts.
• Do not use any abrasive cleaners.
• Remove any food from the freezer. Store in a cool place and keep well covered.
• Switch the appliance off and unplug from the mains, or switch off the circuit
breaker, or remove the fuse.
• Clean the appliance and the interior accessories with a cloth and lukewarm
water. After cleaning, wipe with fresh water and wipe dry.
• After everything is dry, the appliance can be put back into service.
Cleaning the drain hole
To avoid defrost water overflowing into the fridge,
periodically clean the drain hole at back of fridge
compartment. Use a cleaner to clean the hole as
shown in the picture on the right
16
Replacing the lamp
The internal light is a LED. To replace it, please contact a qualified technician.
Defrosting the freezer
The freezer compartment, however, will become progressively covered with frost.
This should be removed. Never use sharp metal tools to scrape off frost from the
evaporator as you could damage it.
However, when the ice becomes very thick on the inner liner, complete defrosting
should be carried out as follows:
• unplug the power cord from the socket;
• remove all stored food, wrap it in several layers of newspaper and put it in a
cool place;
• keep the door open, and place a basin underneath the appliance to collect the
melted ice;
• when defrosting is completed, dry the interior thoroughly;
• replace the plug in the power socket to run the appliance again.

2.4. Troubleshooting

Caution! Before troubleshooting, disconnect the power supply. Only a qualified
electrician or competent technician can perform any troubleshooting that is not
included in this manual.
Important! There will be some noises during normal use (compressor and refrigerant
circulation).
Problem
Possible cause
Appliance is turned off.
Mains plug is not plugged in or is
Appliance does
loose
not work
Fuse has blown or is defective
Socket is defective
Temperature is not properly
adjusted.
Door was open for an extended
period.
The food is not
A large quantity of warm food was
frozen enough.
placed in the appliance within the
last 24 hours.
The appliance is near a heat
source.
Appliance
Temperature is set too cold.
cools too
much
Refrigerator Combi Built-In | Frigorífico Combi Integrable | Frigorífico Combinado Encastrável
EN
Solution
Press "Adjust" button for 5 seconds
to turn on the appliance.
Insert mains plug.
Check fuse, replace if necessary.
Mains malfunctions are to be
corrected by an electrician.
Please look in the Temperature
Setting section.
Open the door only as long as
necessary.
Turn the temperature regulation to
a colder setting temporarily.
Please look in the installation
location section.
Temporarily turn the temperature
regulator knob to a warmer setting.
17
Tabla de contenido

Solución de problemas

loading

Tabla de contenido