Becken BBIC2341 Manual De Instrucciones página 7

10. Attach the rubber gasket to seal the gap between
unit and wooden cabinet on the opening side of the
door.
11. Screw two middle brackets to the wooden cabinet with short screws. Then fit the
middle bracket covers to the brackets on both sides.
Positioning
Install this appliance in a location where the ambient temperature corresponds to the
climate class indicated on the rating plate of the appliance:
Climate class
SN
N
ST
T
Location
The appliance should be installed well away from sources of heat such as radiators,
boilers, direct sunlight etc.
Warning! It must be possible to disconnect the appliance from the mains power
supply; the plug must therefore be easily accessible after installation.
Electrical connection
Before plugging in, ensure that the voltage and frequency shown on the rating plate
correspond to your domestic power supply. The appliance must be earthed. The
power supply cable plug is provided with a contact for this purpose. If the domestic
power supply socket is not earthed, connect the appliance to a separate earth, in
compliance with current regulations, consulting a qualified electrician.
12
Ambient temperature
+10o C to +32o C
+16o C to +32o C
+16o C to +38o C
+16o C to +43o C
The manufacturer declines all responsibility if the above safety precautions are not
observed. This appliance complies with the EU Directives.
First use
Cleaning the interior
Before using the appliance for the first time, wash the interior and all internal
accessories with lukewarm water and some neutral soap so as to remove the typical
smell of a brand new product, and then dry thoroughly.
Important! Do not use detergents or abrasive powders, as these will damage the
finish.
Control Panel
Buttons
B1– Press to adjust the setting of the fridge compartment from the cycle of 1,2,3,4
and 5.
B2– Press to select the mode from Smart, Super and user's settings.
Lights
L1 – shows the setting of the fridge compartment.
L2 – light on if Smart mode is selected.
L3 – light on if Super mode is selected.
Operation
Temperature Setting
1. Press the Mode button (B2) to select user's setting.
2. Press the Adjust button (B1) to adjust the setting of the fridge. A lower setting
means a higher temperature. For example, position 1 is the warmest setting, while
position 5 is the coolest. The temperature of the freezer is automatically set at around
-18ºC.
Smart Mode
Press the Mode button (B2) to select Smart mode.
The appliance will run automatically according to the ambient temperature around
the appliance.
Super Mode
Press the Mode button (B2) to select Super mode.
The appliance will run to make the freezer compartment colder. After 54 hours, the
original temperature set will be automatically restored.
Turn off the appliance.
Press and hold the Adjust button (B1) for 5 seconds, and the appliance will turn off.
Press again for 5 seconds to turn on the appliance.
Refrigerator Combi Built-In | Frigorífico Combi Integrable | Frigorífico Combinado Encastrável
EN
13