Useful Suggestions - TRAPP TRP 40 Manual De Instrucciones

Throghout the use of the shredder situations and or problems may occur, for which
we present some suggestions:
Trouble Probable Cause
Equipment Excess feeding or overload.
Jammed Due to this motor cannot
achieve required rotation, and
the material accumulates in the
shredder (continuous use under
this condition, can cause motor
burn-out due to overload).
Low 1 - Insufficient feeding of the
Production
2 - Motor rotation lower than
3 - Moist or green produce.
4 - Adjustment on shredder is
Irregular 1 - Dull cutting blades.
Chopping
2 - Worn or unbalanced.
Difficulty 1 - Worn or damaged
Grinding Dry
Grains 2 - Hammers are jammed
Difficulty 1 - Excess or overload of
Starting Motor
2 - Drop of high tension or

Useful Suggestions

shredder.
specified.
not consistent with the
material in use.
hammers
produce.
power source.
52
Solution
Turn OFF shredder immediately and wait for
motor to stop. Open hatch and remove the
excess material inside shredder, close hatch.
Once shredder is ready to operate, turn ON
the motor, and wait until rotation reaches its
full speed, only then resume work. Maintain a
steady and regulated amount of input, so as
not to overload motor.
1 - Maintain a continuous feeding flow, yet
not over-feeding which may cause the
shredder to jam.
2 - Verify if purchased motor to be
installed on shredder (shredder sold
without motor) is compatible accoding to
specifications (see sticker on shredder). If
motor rotation is below specification, the
hammers will be delayed causing low
production.
3 - When using funnel only grind dry grains
and/or dry produce. Grinding moist or
green grains/produce will clog and
obstruct strainer.
4 - Select different strainer for your choice
application (coarse or fine).
1 - Sharpen cutting blades
(see page 49).
2 - Follow procedure indicated on page 48.
1 - Revert position or substitute hammers,
consult page 49.
2 - Always clean shredder after usage,
especially after chopping green crop.
1 - Stop feeding shredder, and keep motor
running until clear.
2 - Consult electrician to check power
source.
ENGLISH