Installation; Installing Onto The Vcr; Connecting To A Computer; Setting The Data Transfer Rate - Sony SVT-RS1A Manual De Instrucciones

Tabla de contenido

Installation

Installing onto the VCR

Install the board as illustrated.
Time Lapse VCR
Remove the
blank plate.
Note
To install this board, consult your supplier or Sony service
representative.

Connecting to a Computer

Connect to a computer as illustrated.
RS-232C connector
(9-pin D-SUB type)
9-pin D-SUB type cable (not supplied)
Interface cable to be connected to the RS-232C connector
must be shielded as follows.
Outer shell
Shield
Align the grooves on
both sides of the
connector.
Computer
Interface Board
To a computer

Setting the Data Transfer Rate

After connecting to a computer, set the data transfer rate in
the <OTHER> menu.
1 Press the MENU button on the VCR to display the
<OTHER> menu.
<1 SHOT SET>
FIELD
INTERVAL
<CLOCK SET>
TIME ADJ
00:00
OPERATION
OUT
<OTHER>
REPEAT
MODE1
RS-232C
1200
2 Press the SHIFT $ button to flash "RS-232C", and press
the REC/PLAY SPEED + or – button to set the data
transfer rate (1200, 2400, 4800, or 9600 bps).
3 Press the SEARCH button to return to the normal
screen.
1
1M
EN
10
Tabla de contenido
loading

Tabla de contenido