Reggiani SUPERTECHNE Instrucciones De Montaje página 15

A
For luminaires with discharge lamps and/or HF control gears, the control gear must be
placed outside the recess ( B), in a well-ventilated, dry and suitably sized place (see
fig. ) at a distance of not more than 1.5m from the luminaire.
Important: containers made from materials with a thermal conductivity less than that of
the concrete (=0.78 hcal/mh°C) are not allowed, neither are containers made from
insulating materials.
INSTALLATION/REPLACEMENT OF LAMPS
Disconnect from the mains and follow the instructions given below.
Ideally, before inserting the new lamps, the reflector should be cleaned using a soft dry
synthetic cloth without chemical products, alcohol, detergents or abrasives.
To preserve the brightness of the reflector during installation and maintenance, use the
gloves provided.
According to the item, luminaires of the SUPERTECHNE range can be fitted with lamps
of the following type:
B
• MAINS VOLTAGE HALOGEN LAMPS
Cut-out QT-DE
150mm 150w
220mm 300w
PTL R7s/HDG
LOW VOLTAGE HALOGEN LAMPS
Open the access flap of the optical compartment by acting on the Polyblok spring;
Lift the retaining ring and extract the lampholder.
insert/replace with a lamp with a max. power of 100W (12V) (if necessary, tighten
the safety screws to guarantee a firm grip).
Place the lampholder back in position making sure the lamp filament is brought within
the focus of the reflector.
Close the access flap, making sure the safety glass is in perfect condition.
• METAL HALIDE LAMPS
Cut-out HIT/CDM-T
150mm 35/70/150w
220mm 35/70/150w
242mm —
Wall Washer
35/70w
PTL G12
• SODIUM VAPOUR LAMPS
Cut-out SDW-TG
150mm 50/100w
220mm —
PTL GX12
15
QT-32 GLS
150w —
250w 100w
E27 E27
HIT-DE HIT
70/150w —
70/150w —
— 250/400w
70/150w
Rx7s E40
HST
—
100w
PG12-1
E N G L I S H