Reggiani SUPERTECHNE Instrucciones De Montaje página 14

IMAGE GLASS ref. 6931
To fit image glass, insert the four springs
provided with the accessory into the glass
retainer flange and then attach the glass
as shown in the figure.
SELECTIVE FILTERS ref. 6933
To fit the selective filters, proceed as follows:
open the access flap of the optical compartment and unhook it from the hinge by
pressing lightly on the reflector;
remove; insert the selective filter and make sure the glass is firmly held between
the teeth of the flange and the Polyblok spring;
hinge.
S U P E R T E C H N E
free the glass using the Polyblok spring and
put the access flap back on the
GLASS CYLINDER ref. 6980
Place the glass cylinder in position before installing the luminaire.
CONTAINER FOR CONCRETE CEILINGS ref. 3865 and 3866
The container for concrete ceilings enables a recess to be made to house the
luminaires before the concrete is cast.
Firstly, make sure the container is suitable for the luminaire to be used. Remember
that references 3865 and 3866 must be used with luminaires requiring a recess of,
respectively, 150mm and 220mm with a maximum depth of 150mm.
Then, prepare the container for installation by nailing or screwing the cover onto
the formwork; Drill the holes on the bottom of the container and prepare the
conduit required for the control gear (make sure the concrete cannot leak through
them) and fit the projections of the container into the holes in the cover;
the concrete has been set and the formwork removed, access can be freely gained
to the recess.
14
once