Bosch Professional GCM 10 J Manual Original página 37

OBJ_BUCH-1156-001.book Page 37 Thursday, February 11, 2010 12:08 PM
Sawing Profile Strips/Mouldings (Floor and Ceiling Strips)
Profile strips/mouldings can be sawn in two dif-
ferent ways:
– Placed against the fence
– Lying flat on the saw table.
Floor Strips/Mouldings
The following table contains instructions for sawing floor strips/mouldings.
Settings
Vertical bevel angle
Floor strip/moulding
Inner corner Horizontal mitre
angle
Positioning of
workpiece
The finished
workpiece is lo-
cated...
Outer Horizontal mitre
corner angle
Positioning of
workpiece
The finished
workpiece is lo-
cated...
Bosch Power Tools
Always make trial cuts with the mitre angle set-
ting first on scrap wood.
Placed
against
the fence
0°
Left side Right side
45° left 45° right
Bottom edge Bottom edge
on saw table on saw table
... to the left of ... to the right
the cut of the cut
45° right 45° left
Bottom edge Bottom edge
on saw table on saw table
... to the right ... to the left of
of the cut the cut
English | 37
Lying flat
on the
saw table
45°
Left side Right side
0° 0°
Upper edge Bottom edge
against the against the
fence fence
... to the left of ... to the left of
the cut the cut
0° 0°
Bottom edge Upper edge
against the against the
fence fence
... to the right ... to the right
of the cut of the cut
1 609 929 W04 | (11/2/10)