Environmental Protection; Storage; Repairs; Troubleshooting - Gesipa AccuBird Pro Instrucciones De Manejo Con Lista De Repuertos

2.8

Environmental protection

If batteries need to be replaced, please observe the following:
• Return used GESIPA
• Never discard used batteries into household waste, fire or into water!
Caution!
In all EU countries (except Germany) the relevant national regulations for implementing
the EU guideline shall apply.
• In accordance with the EU Directive 2014/30/EC (WEEE), in Germany, this tool is
registered under the WEEE Reg.-No. DE 45695505. If the tool has an 8-digit serial num-
ber it can be returned free of charge to GESIPA
2.9

Storage

The blind rivet setting tool should be stored in a dry place where there is no danger of frost.

2.10 Repairs

Repairs under warranty are carried out by the manufacturer. Repairs outside the warranty
period should only be carried out by skilled technical personnel. Failure to observe the
assembly and setting procedures and operation by non-skilled personnel may result in seri-
ous damage to the blind rivet setting tool. In case of doubt, always send the blind rivet set-
ting tool back to the supplier or to GESIPA
You can find the spare parts for your tool online at www.gesipa.com.
3.

Troubleshooting

3.1

Blind rivet cannot be set

Cause
No battery
Jaws dirty or worn
Jaw assembly loose
rechargeable batteries to your dealer or to GESIPA
®
.
®
Remedy
Charge battery; replace if necessary
Clean them and lubricate or grease the sliding surfaces
or replace them (see 2.7)
Tighten (see 2.7)
for correct disposal.
®
GB
for recycling.
®
21