Operation - RIDGID R213BNF Manual Del Operador

OPERATION

DANGER:
Do not use oxygen, combustible gases or bottled
gases as a power source for this tool. The tool will
explode and cause death or serious injury.
WARNING:
Do not allow familiarity with tools to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict severe injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1. Failure to do
so could result in objects being thrown into your
eyes resulting in possible serious injury.
WARNING:
Disconnect the tool from the air supply before
leaving the work area, moving the tool to another
location, or handing the tool to another person.
Failure to do so could result in serious personal
injury.
APPLICATIONS
You may use this tool for the purposes listed below:
 Finish and Trim (interior and exterior)
 Decorative Trim
 Book Cases
 Baseboard
 Cabinets
 Case Backs
 Drawers
 Molding
 Mirror and Picture Frames
 Paneling
 Shoe & Base Moldings
 Staircases
 Upholstery Trim Panels
 Wainscoting
 Window Beading
 Chair Rail
 Furniture Frames
 Lattice Strip Molding
 Nailable Plastic Parts
 Crafts
WARNING:
Always wear eye protection. Eye protection does
not fit all operators in the same way. Make sure the eye protection chosen has side shields or provides
protection from flying debris both from the front
and sides.
PREPARING THE TOOL FOR USE
This is an oil-free tool, therefore lubrication is not required.
However, the occasional addition of air tool lubrication into
the air fitting on the tool will not adversely affect performance
or harm the tool.
Before connecting the tool, check the air compressor gauge
to be sure it is functioning within the proper range of 70-
120 psi.
NO-MAR PAD
See Figure 1, page 13.
The no-mar pad attached to the workpiece contact helps
prevent marring and denting when working with softer
woods.
WARNING:
Disconnect the tool from the air supply before
removing or replacing the no-mar pad. Failure to
do so could result in serious personal injury.
The no-mar pad can be removed by pulling it down and
away from the workpiece contact. To replace the no-mar
pad, fit it into place over the workpiece contact and push
up at the back to reseat.
On-board storage for the no-mar pad is located on the
magazine of the tool. Two extra no-mar pads are provided
in the on-board storage area.
BELT HOOK
See Figure 2, page 13.
The hook will rotate to either side of the tool and can be used
to hang the tool from a belt when the tool is disconnected
and not in use.
CLEAN DRIVE
See Figure 3, page 13.
This nailer is designed with CLEAN DRIVE
help drive nails flush at angles and avoid marks and dents
in material. The small nose helps improve nail placement.
7 – English
TECHNOLOGY
™
™
Technology to