Features; Assembly; Operation - RIDGID R09890 Manual Del Operador

FEATURES

PRODUCT SPECIFICATIONS
Fastener Type .............................................18 ga. brad nail
Fastener Range ...................................... 5/8 in. to 2-1/8 in.

ASSEMBLY

WARNING:
Do not use this product if it is not completely
assembled or if any parts appear to be missing or
damaged. Use of a product that is not properly and
completely assembled or with damaged or missing
parts could result in serious personal injury.
If any parts are damaged or missing, please call 1-866-539-1710 for assistance.

OPERATION

WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict severe injury.
WARNING:
Always remove battery pack from the tool when
you are assembling parts, making adjustments,
cleaning, or when not in use. Removing battery
pack will prevent accidental starting that could cause serious personal injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1. Failure to do
so could result in objects being thrown into your
eyes, resulting in possible serious injury.
APPLICATIONS
You may use this tool for the purposes listed below:
 Finish and Trim (Interior and Exterior)
 Door & Window Casing
 Door Jambs
 Baseboard
 Crown Molding
 Cabinetry
 Cap and Shoe Molding
 Molding
Magazine Capacity ............................................... 105 nails
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended
for use with this product. Any such alteration
or modification is misuse and could result in a
hazardous condition leading to possible serious
personal injury.
 Staircases
 Door and Window Trim
 Chair Rail
 Brickmold
 Hardwood Flooring
 Paneling
 Furniture
ATTACHING THE BELT CLIP
See Figure 1, page 13.
The belt clip can be installed on the left or right side of the
nailer, depending on operator preference.
 Align belt clip and screw with right or left side screw hole.
 Using a Phillips head screwdriver (not included), tighten
securely.
INSTALLING/REMOVING BATTERY PACK
See Figure 2, page 13.
 To install, place the battery pack in the tool. Align raised
rib on battery pack with the groove inside the tool.
 Make sure the latches on both sides of the battery pack
snap into place and the battery pack is secured in the
tool before beginning operation.
NOTE: Squeeze LED worklight grip switch to activate nailer.
 To remove, locate latches on both sides of the battery
pack and depress to release the battery pack from the
tool.
For complete charging instructions, see the operator's
manuals for your battery pack and charger.
8 - English