DeWalt DW756 Manual De Instrucciones página 9

MAINTENANCE
WARNING: To reduce the risk of injury, turn unit off
and disconnect it from power source before installing and
removing accessories, before adjusting or when making
repairs. An accidental start-up can cause injury.
Cleaning
WARNING: Blow dirt and dust out of all air vents with clean, dry air
at least once a week. To minimize the risk of eye injury, always wear
ANSI Z87.1 approved eye protection when performing this.
WARNING: Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. These chemicals may
weaken the plastic materials used in these parts. Use a cloth
dampened only with water and mild soap. Never let any liquid get
inside the tool; never immerse any part of the tool into a liquid.
Accessories
WARNING: Since accessories, other than those offered by
D WALT, have not been tested with this product, use of such
E
accessories with this tool could be hazardous. To reduce the risk of
injury, only D WALT recommended accessories should be used with
E
this product.
Grinding wheels must fit within the confines of the guard and must be
rated higher than the recommended speed as marked on the bench
grinder nameplate.
Recommended accessories for use with your tool are available at
extra cost from your local dealer or authorized service center. If you
need assistance in locating any accessory, please contact D
Industrial Tool Co., 701 East Joppa Road, Towson, MD 21286,
call 1-800-4-D WALT (1-800-433-9258) or visit our website: www.
E
dewalt.com.
WARNING: To reduce the risk of injury, always use proper guards
when grinding and wear eye protection.
CAUTION: Strands of wire cup brushes may break and fly off while
in use. Users and others in the area should wear adequate eye, face
and body protection. Use only wire cup brushes that are rated at or
greater than the RPM shown on the tool's nameplate.
CAUTION: The use of any non-recommended accessory may be
hazardous.
Changing Accessories (Fig. 2, 5, 6, 7)
Change accessories when the spark guard can no longer be adjusted
to 1/16" (1.6 mm) from the wheel.
DW756 - use only wheels that
measure 6" (152 mm) in
diameter. This tool has 1/2"
(13 mm) arbors on each side.
DW758 - use only wheels
that measure 8" (200 mm) in
diameter. This tool has 5/8"
(16 mm) arbors on each side.
Follow the steps
to remove and replace an
accessory.
1. Raise the eye shield (B).
2. Loosen, but do not remove,
the tool rest bolts (H, Fig. 2)
and pull the tool rest (D) out
WALT
E
as far as possible. Do not
remove it.
3. Loosen, but do not remove,
the spark guard bolts (O,
7
FIG. 5
A
T
below
U
T
D
B