Activating And Replacing A Battery For Remote Card - Sony SDM-V72W Manual De Instrucciones

Activating and replacing a battery for remote card

Setup 1
1
Activating the remote card
To activate the battery for the remote card,
remove the plastic slip by pulling the tab.
Replacing the remote card battery
1 To replace the worn battery with a new
one, remove the battery compartment
from the remote card by pressing the
lock latch to the right, then pull out the
compartment.
2 Be sure that the positive terminal (+) of
the CR2025 lithium battery is facing
upward.
3 Close the battery compartment to with a
gentle push until you hear the click.
The worn battery should be disposed
2
properly. Check with your local regulations.
- 9 -
Handle the remote card with care. Do
z
not try to bend it, drop it or get it wet. Avoid
placing it near a heater, in direct sunlight, or
where humidity is high.
Caution: Keep the batteries away from the
reach of young children. Batteries may pose
a potential health hazard if put in their
mouth (i.e., they may swallow it or choke on
it).