Light Kit Assembly, 1-Light Option - Craftmade C211 Guia De Instalacion

9. Light Kit Assembly, 1-light Option.

*For Model C211
Remove all 3 screws from switch housing cap
(at top of light kit fitter).
Locate BLUE (or BLACK) and WHITE wires in
switch housing labeled LIGHT. Remove and
discard plastic that holds these 2 wires
together.
Connect WHITE wire from switch housing to
WHITE wire from light kit fitter. Connect BLUE
(or BLACK) wire from switch housing to BLACK
wire from light kit fitter. Be sure molex
connections snap together completely.
Align holes in switch housing cap with holes in
switch housing. (NOTE: The gap on the edge of
the switch housing cap must align with the
reverse switch on the switch housing for the
proper fit.) Re-insert 3 screws that were
previously removed. Securely tighten all
3 screws with a Phillips screwdriver.
Install bulbs included with light kit.
IMPORTANT: When you need to replace bulbs,
please allow bulbs and shade to cool down
before touching them.
Remove finial, finial plate and threaded washer
from threaded rod at bottom of light kit fitter.
Raise shade in order to guide pull chains
through appropriate holes at bottom of shade.
Align threaded rod on light kit fitter with hole
in middle of shade and push up gently,
allowing threaded rod to come through hole.
Thread fan pull chain through hole in plate at
bottom of light kit fitter. Align hole in plate with
pull chain nut on switch housing. (Be sure pull
chain for fan operation does not rub against bulb
during operation.) Secure shade with threaded
washer. Do NOT overtighten threaded washer as
shade may crack or break.
Align hole in center of finial plate with
threaded rod, allowing pull chains to come
through appropriate holes in finial plate, and
push up. Thread center pull chain through hole
in finial and re-attach finial. Do NOT overtighten
finial as shade may crack or break.
Please proceed to Section 11 on page 10 to
complete installation.
molex
connections
reverse
switch
switch
housing
molex
connections
light kit fitter
threaded
washer
page 8
motor housing
switch housing
switch housing cap
light kit fitter
pull chain
nut
fan pull chain
blue
(or black)
white
wire wire
white wire black wire
bulb
finial plate
finial
shade