Canopy Assembly; Blade Assembly - Craftmade C211 Guia De Instalacion

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

7. Canopy Assembly.

Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen
the other screw. Lift canopy to hanging
bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging
bracket and push up. Twist canopy to lock.
Re-insert screw that was removed, and then
tighten both screws securely.

8. Blade Assembly.

Time Saver: If not already pre-attached,
washers for blade screws can be set on each
blade screw prior to installing blades.
Locate 15 blade attachment screws and
washers in hardware pack. Hold blade arm
up to blade (sold separately) and align holes.
Insert 3 blade attachment screws (along
with washers) with fingers first and then
tighten screws securely with a Phillips
screwdriver. Repeat procedure for the
remaining blades.
Remove blade arm screws/lock washers
from underside of motor. If plastic motor
locks are installed with blade arm screws,
discard plastic motor locks (save blade arm
screws/lock washers to secure blade arms).
Align blade arm holes with motor screw
holes and attach blade arm with blade arm
screws/lock washers. Before securing screws
permanently, repeat procedure with
remaining blade arms. Securely tighten all
screws.
NOTE: Tighten blade arm screws twice a
year.
screw
plastic
motor
lock
blade arm
screws/lock
washers
page 7
hanging bracket
canopy
blade screw and washer
motor housing
blade attachment
screws and washers
blade
blade arm

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

C215

Tabla de contenido