DeWalt P35s Manual Del Usario página 6

P35s
For installations in A 36 steel, 1/2" (13mm) is the recommended minimum edge distance.
SPACING
The recommended minimum distance between fastenings is 1-1/2" (38mm) center to
center for installations in ASTM A 36 steel.
FASTENER LENGTH SELECTION IN STEEL
For permanent applications when using pins in steel, first determine the thickness of
the fixture to be fastened. To this, add the thickness of the steel base material plus a
minimum of 1/4" (6mm) to allow for proper point penetration. This will be the minimum
fastener shank length required. Do not select a fastener length longer than that required
for the application.
An excessively long shank can burnish or polish the hole created in the steel
resulting in a reduction in load capacity.
For removable applications with threaded studs, the shank length required is equal
to the thickness of the steel base material plus a minimum of 1/4" (6mm) to allow for
proper point penetration. This will be the minimum fastener shank length required. Do
not select a shank length longer than that required for the application. An excessively
long shank can burnish or polish the hole created in the steel resulting in a reduction
in load capacity. To determine the minimum threaded length, add the thickness of the
fixture and the nut / washer thickness. The nut and washer thickness is equal to the
nominal thread diameter.
Do not over tighten threaded studs, the maximum tightening torque is listed in
the table below. Use of a nut setter is recommended to reduce the possibility of over
tightening the fasteners. For critical applications, perform a job site test.
POWDER LOAD SELECTION GUIDE
.25 CALIBER 10 LOAD STRIPS
CAT # POWER LEVEL
50570-PWR
50574-PWR
50678-PWR
.25 CALIBER 10 LOAD STRIPS MASTER PACK
CAT # POWER LEVEL
50572-PWR
50576-PWR
50580-PWR
FASTENER SELECTION GUIDE
8mm HEAD DIAMETER DRIVE PINS: Shoots pins 12.7mm to 38.1mm
(1/2" to 1-1/2") length
.300" HEAD DIAMETER DRIVE PINS: Shoots pins 1/2" to 1-1/1" length
1/4" -20 THREADED STUDS
CAT # THREAD
LEN
50322-PWR 3/4"
50326-PWR 3/4"
50328-PWR 1/2"
LOAD COLOR
3 Green
4 Yellow
5 Red
LOAD COLOR
3 Green
4 Yellow
5 Red
THREAD SHANK
DIA LEN
1/4" 1/2" (K)
.1/4" 3/4"
.1/4" 1"
BOX CTN
100 1000
100 1000
100 1000
BOX CTN
1000 20000
1000 20000
1000 20000
SHANK CTN
DIA
.145 100
.145 100
.145 100
EN
6
MSTR CTN WT./ 100
20000 .28
20000 .28
20000 .28
MSTR CTN WT./ 100
.33 .28
.33 .28
.33 .28
MSTR WT./
CTN 100
1000 1.1
1000 1.2
1000 1.2