Setting Of Temperatures; Using The Pre-Settings In The Menu - Xylem SI Analytics CT 72/2 Manual De Instrucciones

5.

Setting of temperatures

5.1. Using the pre-settings in the
Factory setting:
SETPNT 1 25 °C
SETPNT 2 37 °C
SETPNT 3 70 °C
Setting of temperatures
menu
Press the key to call up the menu for temperature selection.
3 different working temperatures can be adjusted. Their values are freely selectable
within the operating temperature range.

The temperatures can be set in start or stop mode.

Press key if a value is to be retained
Setting of working temperature in the
1. Press the key
2. Select SETPOINT 1 or 2 or 3 using the key
3. Confirm by pressing the

The circulator uses the new working temperature value for temperature control.
Example: Adjustment/modification of the pre-setting of
"SETPOINT 3"
1. Press the key.
2. Select SETPOINT 3 by pressing the
Example: SETPNT 3 / 70.00 °C
3. Keep the
(example: <70>)
4. Adjust value by pressing the
by pressing the
The decimal digits flash
Confirm once more by pressing the
Example on the left: SETPNT 3 / 85.00.

If the active setpoint (SETPNT) is changed, the new value is
immediately used for the control of the working temperature.
The heater control indicator flashes.

If the other two setpoints (not activated for control) are changed the
MENU has to be left by pressing the
digits have been confirmed
Notice: Refer to SETPOINT MAX / MIN in chapter
7.7. MENU LIMITS
. The value flashes
key.
key pressed until the integer digits flash
key and the
key.
and can be adjusted if desired.
72
menu
or .
key.
.
key to 85.00 °C and confirm
key.
key after the decimal