Gas Requirements And Connection - Thermador Professional Serie Manual Del Usuario

Installing the anti-tip bracket for 60'' models
1. Locate the anti-tip bracket in the literature packet,
inside the box that was on top of the appliance.
2. Place bracket on the floor in a position shown below.
The bracket may be placed on either the left or the
right side.
3. For walls, wall studs, or floors composed of solid
wood or metal, drill 1/8'' (3 mm) pilot holes.
4. Secure to floor and/or wall stud using the (4) 1 ½''
(38 mm) Phillips head screws provided.
C L
x x
Model
60''
Later, when the unit is installed, the caster will slide under
the bracket. If the range is moved to a new location, the
anti-tip device must be removed and reinstalled.
Gas requirements and
connection
9 CAUTION
The appliance must be isolated from the gas supply
piping system by closing its individual manual shut-off
valve during any pressure testing of the gas supply
piping system at test pressures equal to or less than 1/
2 psig (3.5kPa.).
9 WARNING
DO NOT use a flame of any kind to check for gas
leaks.
9 CAUTION
When connecting unit to propane gas, make certain
the propane gas tank is equipped with its own high
pressure regulator in addition to the pressure
regulator supplied with the appliance. The pressure of
the gas supplied to the appliance regulator must not
exceed 14" water column (34.9 mb).
Page. 17
C L
C L
x x
Value for 'X'
2'' (51 mm)
Verify the type of gas being used at the installation site.
Make certain the range matches the type of gas available
at this location.
The gas supply connections shall be made by a competent
technician and in accordance with local codes or
ordinances. In the absence of local codes, the installation
must conform to the National Fuel Gas Code ANSI
Z223.1/NFPA54- current issue.
High altitude
This appliance has been tested for operation up to an
altitude of 10,100 ft (3,078 m) elevation above sea level.
A high altitude kit is required for natural gas above 5,400
feet (1,646 m) elevation above sea level, and for propane
(LP) above 10,000 feet (3048 m) elevation above sea level.
If desired, for altitudes above 2,000 feet (610 m) elevation
above sea level, adjustments can be made to the
rangetop burners with an adjustment kit. If flame
performance is satisfactory, adjustment will not be
required. It is required that a Certified Professional make
the high altitude adjustments during installation.
See the back cover for information about service, parts,
and accessories.
Gas requirements
Natural gas requirements:
• Inlet Connection: 1/2'' NPT internal (Minimum 3/4''
dia. flex line)
• Supply Pressure: 7'' min. to 14'' max. water column
(17.4 to 34.9 mb)
• Manifold Pressure: 5'' water column (12.5 mb)
Propane gas requirements:
• Inlet Connection: 1/2'' NPT internal (Minimum 3/4''
dia. flex line)
• Supply Pressure: 11'' min. to 14'' max. water column
(27.4 mb to 34.9 mb)
• Manifold Pressure: 10'' water column (24.9 mb)