Bosch MTS 6516 VCI Manual Original página 26

en 26 | MTS 6516 VCI |
6. Select the Enable Wireless Interface check box in
the Interface Control section. Once you enable the
interface, the IP Address Configuration box and the
Apply and Cancel buttons become active.
7. Select Obtain an IP address automatically if your
LAN automatically assigns IP addresses. Otherwise
enter the assigned IP Address and Subnet mask
given to you by your IT Administrator.
8. Select Access Point to begin wireless access point
configuration.
9. Specify the network name:
i
If you are not within range of the access point you
will use, select the Enter Network Name [SSID]:
radio button and type the network name.
i
If you are within range of your wireless access point,
choose the Select from available network list radio
button and then select Refresh to cause the VCI to
search for wireless network signals. The detected
networks are displayed in the Network Name box.
10. After you have entered the network name, select
Configure.
11. Enter the security settings that are required by your
network, then select Next.
12. Select Yes to reconfigure your VCI, or if you want to
start over select No.
13. Choose the Properties tab to verify that the VCI is
configured correctly. You can also disconnect the
USB cable to verify that the wireless connection is
working.
14. Record or print your settings as they are displayed
on the Properties tab for future reference.
|
1699200075 B 2017-06-20
5.3.2 Enabling Point-to-Point Wireless Communica-
tion
Your VCI can be configured for Point-to-Point Wireless
Communication. Before starting, please verify the fol-
lowing:
R
Your VCI kit is the Wireless-Point-to-Point kit (p/n
F-00K-108-867) which includes the MTS 6516 VCI
assembly with a Wi-Fi card and a DLink Wireless
802.11n USB Adapter.
The following illustration shows a single VCI connected
to a laptop PC using Point-to-Point Wireless communi-
cation.
Use the following procedure to configure your VCI for
Point-to-Point Wireless communication. Note that the
steps presented below assume you are running the
Windows 7 operating system on your PC. The steps for
other versions of the Windows operating system may be
slightly different.
1. Insert the Wireless USB adapter in an available USB
port on your PC.
2. Power-on your PC.
3. Connect the VCI to your PC using the USB cable.
i
Allow the VCI to boot completely.
4. Start the VCI Manager software by double-clicking
the icon on the PC desktop.
5. Select the VCI in the VCI Manager Explorer tab and
click the Connect button.
6. Select the Wireless 802.11 tab.
7. Select the Enable Wireless Interface checkbox.
Robert Bosch GmbH