Hitachi NR 90AF Instrucciones Y Manual De Seguridad página 18

English
1 Set the switching device to the upward
position (to set to SINGLE ACTUATION
MECHANISM).
(Set the switching device to the upward
position completely as shown in the
diagram. Otherwise, it will be set to
CONTACT ACTUATION MECHANISM.)
2 Position the nail outlet on the
workpiece with finger off the trigger.
3 Depress the push lever firmly until it is
completely depressed.
4 Pull the trigger to drive a nail.
5 Remove finger from the trigger.
To continue nailing in a separate location,
move the nailer along the wood, repeating
steps 2 - 5 as required.
Trigger
4
3
Push lever
(2) Continuous operation (Push lever fire)
Using CONTACT
MECHANISM
To avoid double firing or accidental
firing due to recoil.
1) Do not press the nailer against the
wood with excessive force.
1 Upward position
Switching device
ACTUATION
WARNING
2) Separate the nailer from the wood
as it recoils after nailing.
1 Set the switching device to the
downward position (to set to CONTACT
ACTUATION MECHANISM).
(Set the switching device to the
downward position completely as
shown in the diagram. Otherwise, it will
not operate properly.)
2 Pull the trigger with the Nailer off the
workpiece.
3 Depress the push lever against the
workpiece to drive a nail.
4 Move the Nailer along the workpiece
with a bouncing motion.
Each depression of the push lever will
drive a nail.
As soon as the desired number of nails
have been driven, remove finger from the
trigger.
Previously pull the trigger
4
— 18 —
Switching device
1 Downward position
2
Push lever