Husqvarna FS7000 D Manual Del Usuario página 25

2. Close the water valve.
3. Set the lever for speed control to the stop position.
4. Make sure that the transmission bypass valve is
Product overview, right side
closed. Refer to
(FS7000 D) on page 4 or Product overview, right
side (FS7000 DL) on page 6 for the position of the
transmission bypass valve.
5. Turn the engine start switch to ignition on position
(A).
A
6. If the preheating symbol shows on the display, wait
until it goes off. Refer to
control panel display on page 9 .
7. Turn the engine start switch to engine start position
(B). The engine starts.
B
1223 - 002 - 09.07.2019
Warning symbols on the
8. Let the engine operate at idle speed for 2-3 minutes
until the temperature gauge starts to move.
CAUTION: Do not let the engine operate
at low idle speed when the product is not
in operation. Low idle speed increases
the quantity of particles in the engine
and decreases the time between
regenerations. Only applicable for
products that comply with the Euro V
Emission standard.
WARNING: For products without a blade
clutch, the cutting blade starts to rotate
when the engine starts and the gear is
not in neutral. Do not move the product
to the side or out of the work area if the
cutting blade rotates.
To operate the product
1. Start the engine.
2. Push the button adjacent to the symbol for the water
safety system. The symbol on the display changes
color to show that the function is engaged.
3. Open the water valve.
2
1
3
0 4
12
150
10 14
5.0
WORKING HOURS
8 18 110
V
CURRENT: STOP:
180
210
250
˚F
25