Husqvarna FS7000 D Manual Del Usuario página 21

The gearbox has 3 speed positions and 2 neutral
positions available. When the gearbox is set to neutral
position, the cutting blade does not rotate when the
engine is on.
1. Turn the engine start switch to the stop position.
2. Make sure that the dimension of the gearbox pulleys,
blade shaft pulleys and blade shaft flanges are
correct for the dimension of the installed cutting
blade.
3. Make sure that the blade shaft speed is correct.
4. Turn the knob (A) 2 revolutions counterclockwise to
loosen the locknut.
A
1223 - 002 - 09.07.2019
B
3
N 1 N
2
5. Loosen the locknut fully but do not remove it.
6. Move the gearshift lever (B) to the applicable gear. If
it is not easy to move the gearshift lever, turn the
blade shaft a small distance.
7. Tighten the knob clockwise with your fingers.
8. Tighten the locknut with the supplied blade shaft
Product overview, left side (FS7000
wrench. Refer to
D) on page 3 or Product overview, left side (FS7000
DL) on page 5 .
21