Mounting The Bar And Chain (Quick Chain Tensioner) - Stihl MS 261 Manual De Instrucciones

1
3
1
2 4
Fit the guide bar over the studs (1) –
N
the cutting edges on the top of the
bar must point to the right.
Engage the peg of the tensioner
N
slide in the locating hole (2) –- place
the chain over the sprocket (3) at
the same time.
Turn the tensioning
N
screw (4)clockwise until there is
very little chain sag on the
underside of the bar – and the drive
link tangs are engaged in the bar
groove.
Refit the sprocket cover and tighten
N
the nuts only moderately by hand
(they are finally tightened after the
saw chain is tensioned).
Go to chapter on "Tensioning the
N
Saw Chain"
MS 261, MS 261 C
Mounting the Bar and
Chain (quick chain
tensioner)
Remove the chain sprocket cover.
1
3
2
Pull out the hinged clip (1) so that it
N
snaps into position.
Turn the wingnut (2)
N
counterclockwise until it hangs
loose
in the sprocket cover (3).
N
Removing the sprocket cover
N
Fitting the tensioning gear
1
Remove the tensioning gear (1) and
N
turn it over.
2
Unscrew the nut (2).
N
1
4
5
Position the tensioning gear (1)
N
against the guide bar (3) so that the
stud (4) projects through the upper
hole and the short guide peg (5)
locates in the lower hole.
English
3
25