Cutting Attachment; Mounting The Bar And Chain (Quick Chain Tensioner) - Stihl MSA 160 C Manual De Instrucciones

Cutting Attachment

A cutting attachment consists of the saw
chain, guide bar and chain sprocket.
The cutting attachment that comes
standard is designed to exactly match
the chain saw.
1
a
The pitch (t) of the saw chain (1),
–
chain sprocket and the nose
sprocket of the Rollomatic guide bar
must match.
The drive link gauge (2) of the saw
–
chain (1) must match the groove
width of the guide bar (3).
If non-matching components are used,
the cutting attachment may be damaged
beyond repair after a short period of
operation.
MSA 160 C, MSA 200 C
Chain scabbard
2
Your saw comes standard with a chain
scabbard that matches the cutting
attachment.
3
If you use guide bars of different lengths
on the saw, the length of the chain
scabbard must be matched to the guide
bar to reduce the risk of injury. It should
cover the full length of the guide bar.
The length of the matching guide bars is
marked on the side of the chain
scabbard.
Mounting the Bar and Chain
(quick chain tensioner)
Removing the chain sprocket cover
Set hand guard to ƒ
N
Remove the battery from the
N
machine
1
3
Swing grip (1) into position (until it
N
engages)
Turn the wing nut (2) to the left until
N
it hangs loosely in the chain
sprocket cover (3)
Remove chain sprocket cover (3)
N
Mounting the tensioning gear
1
Remove and reverse tensioning
N
gear (1)
English
2
27