Special Accessories - Stihl MS 261 Manual De Instrucciones

Rollomatic guide bars
Reduced kickback STIHL guide bar
(with green label)
Cutting lengths: 16, 18, 20 in. (40,
45, 50 cm)
Pitch: .325" (8.25 mm)
Groove width: 0.063 in. (1.6 mm)
Nose sprocket: 11 teeth
.325" saw chain
Low kickback STIHL saw chain (with
green label)
Rapid Micro Comfort 3 (26 RMC3)
Pitch: .325" (8.25 mm)
Drive link gauge: 0.063 in. (1.6 mm)
Chain sprocket
7-tooth for .325"
To ensure compliance with the kickback
properties required in Section 5.11 of
ANSI B 175.1-2000, only use
replacement chains that, when used
with this specific powerhead, comply
with Section 5.11 of the ANSI standard
or are classed as "low kickback" chains
according to ANSI B 175.1-2000.
Please ask your STIHL dealer for the
latest recommendations on new
bar/chain combinations developed after
publication of this instruction manual.
MS 261, MS 261 C

Special Accessories

Contact your STIHL dealer for
information regarding special
accessories that may be available for
your product.
Chain scabbard
If you use guide bars of different lengths
on the saw, the length of the chain
scabbard must be matched to the guide
bar to help reduce the risk of injury.
If the chain scabbard does not cover the
full length of the guide bar, a suitable
chain scabbard or a scabbard extension
is necessary.
Depending on the model, the scabbard
extension either comes standard with
the saw or is available as a special
accessory.
Fitting the chain scabbard extension
onto the scabbard
The scabbard extension has two square
cut-outs (1) that fit onto one of several
sets of locking tabs (2, 3, 4) located on
the scabbard. Each set of locking tabs is
marked with the lenght of the bar to
which they correspond, given in
centimeters on one tab and in inches on
the other.
1 2 3 4
cm
INCH
1 2 3 4
Determine the appropriate set of
N
tabs to be used based on the length
the bar
Push the scabbard extension over
N
the scabbard until the cut-outs align
with desired set of tabs, and let
them lock together
English
57