Keypad; System Assembly Without Humidification; Keypad And Display - DeVilbiss Healthcare SleepCube Standard CPAP DV51 Serie Guía De Instrucciones

SyStEm aSSEmbly
10. Air Inlet Filter Opening
11. Connector Cover (not shown)

Keypad

(Figure c)
1. On/Off
2. Previous Item
3. Next Item
4. Delay
5. Decrease Value
6. Increase Value
7. Heater Power LED (for optional humidifier)
Ask your home care provider for information about other
DeVilbiss masks, equipment, and accessories.

sysTem assembly wiTHoUT HUmiDifiCaTion

NOTE–
If your system includes a humidifier, please refer to the instructions provided with the humidifier for assembly and operation.
1. Locate the air supply port and heater accessory connector on the bottom of the SleepCube device. Ensure that each opening has the appropriate
soft cover securely attached.
2. Place the SleepCube on a stable surface such as a nightstand or table. If you wish, you may also place the device on the floor at the bedside,
being careful to place the unit where it won't be kicked or stepped on. Ensure that the air inlet in the back of the device is not blocked by
anything such as curtains or bedding.
NOTE–
Never place the SleepCube system on a soft surface such as a bed or couch during operation.
cAuTION–
The height of the SleepCube system must always be lower than the interface mask when using a humidifier to prevent water from getting into the CPAP mask.
3. Insert the power cord into the back of the device. Make sure the power cord is fully inserted into the connector. Plug the other end of the power
cord into the AC wall outlet.
4. Attach the air supply tubing to the air supply interface in the back of the device.
5. Prepare the mask (supplied by your home care provider) by referring to the mask's instruction guide.
6. Connect the air supply tubing to the mask.
NOTE–
The air supply tubing supplied with the device is specially designed to prevent kinking and allow you to receive optimal airflow. Use only the 22 mm diameter,
smooth-bore, kink-resistant tubing supplied with this device or an air supply tubing recommended by your home care provider.

Keypad And Display

Basic DeVilbiss Sleepcube controls
Name Symbol Function
ON/OFF The ON/OFF button starts and stops the flow of air from the device.

HEATER If your SleepCube has a heater/ humidifier attached, these buttons adjust the heater setting. Increase the setting for
more humidity and decrease the setting for less humidity.

DELAY The Delay button activates the comfort delay feature and only functions if this feature has been enabled. To understand
how to set the parameters of this feature, please refer to the Using the Comfort Delay Feature found on page 8.
NOTE–
The additional control buttons that you see on the SleepCube control panel provide advanced controls for specific settings. Please refer to the 'Advanced Menu
Controls' section on page 8 for more details.
EN
c
3
2
1
4
5
6
7
SE-DV51
7