Tabla de contenido
Idiomas disponibles
Idiomas disponibles
POTENTIAL FOR
ELECTROMAGNETIC INTERFERENCE
To avoid inaccurate results caused by
electromagnetic interference between
electrical and electronic equipments,
do not use the device near a cell
phone or microwave oven.
29
TROUBLESHOOTING
If any abnormality arises during use, please check the following points
POSSIBLE
SYMPTOMS
CAUSES
Unit does not turn on
Batteries have
when the START/STOP
run down.
button is pushed.
Battery polarities
have been positioned incor-
rectly.
EE measurement error
Cuff has been placed
symbol shown on display
incorrectly.
or the blood pressure
value is displayed exces-
Did you talk or move
sively low
during measurement?
(or high).
Shaking of the arm with
the cuff on.
E1 error symbol shown
Air circuit abnormality.
on display
Cuff tube may not be
plugged into monitor
correctly.
E2 error symbol shown
Inflation pressure exceed-
on display
ing 300 mmHg.
E3 error symbol shown
Error determining meas-
on display
urement data.
CA Appears on
Recalibration alert.
display
Note: If the unit still does not work, contact HoMedics Consumer Relations. Under no
circumstance should you disassemble or attempt to repair the unit by yourself.
Contact information for HoMedics Consumer Relations Department can be
found on the warranty page.
CORRECTION
Replace them with
four new AA
alkaline batteries.
Re-insert the batteries in
tions.
the correct posi
Wrap the cuff properly so
that it is positioned
.
correctly
Measure again. Keep arm
steady during measure-
.
ment
Check cuff connection.
Measure again.
Switch the unit off, then
measure again.
Measure again.
Refer to page 26 for
more information.
30
Capítulos
Tabla de contenido
