General Information - Hilti DX 36 Manual De Instrucciones

d) The tool must be allowed to cool down if the
plastic cartridge strip begins to melt.
1.1.8 Danger of explosion
en
a) Use only cartridges of a type approved for use
with the tool.
b) Remove the cartridge strip from the tool carefully.
c) Do not attempt to forcibly remove cartridges from
the magazine strip or tool.

2 General information

2.1 Safety notices and their meaning
DANGER
Draws attention to imminent danger that will lead to
serious bodily injury or fatality.
WARNING
Draws attention to a potentially dangerous situation that
could lead to serious personal injury or fatality.
CAUTION
Draws attention to a potentially dangerous situation that
could lead to slight personal injury or damage to the
equipment or other property.
NOTE
Draws attention to an instruction or other useful informa-
tion.
2.2 Explanation of the pictograms and other
information
Warning signs
General Warning:
warning explosive
substances
Obligation signs
Wear Wear a hard
protective
glasses
20
Warning: hot
surface
Wear ear
hat protection
d) Store unused cartridges in a locked place where
they are not exposed to dampness or excessively
high temperatures.
1.1.9 Personal protective equipment
The user and any other persons in the vicinity must
wear suitable eye protection, a hard hat and ear
protection while the tool is in use or when remedying
a problem with the tool.
Symbols
Read the
operating
instructions
before use
Location of identification data on the tool
The type designation and serial number can be found on
the type identification plate on the tool. Make a note of
this data in your operating instructions and always refer
to it when making an enquiry to your Hilti representative
or service department.
Type:
Generation: 01
Serial no.: