Assembly And Operation; Applications; Removal And Installation Method Of Battery; Charging Method - Hitachi WH 18DSDL Manual De Instrucciones

APPLICATIONS

<WH18DSDL>
Driving and removing of machine screws, wood
screws, tapping screws, etc.
<WR18DSDL>
Tightening and loosening of all types of bolts and
nuts, used for securing structural items
REMOVAL AND INSTALLATION METHOD
OF BATTERY
1. Battery removal
Hold the handle tightly and push the battery latch to
remove the battery (see Fig. 3).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 3).
Insert
Pull out
Fig. 3

CHARGING METHOD

NOTE:
Before plugging into the receptacle, make sure the
following points.
The power source voltage is stated on the
nameplate.
The cord is not damaged.
WARNING:
Do not charge at voltage higher than indicated on
the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn out.
01Eng_WH18DSDL_US.p65

ASSEMBLY AND OPERATION

Handle
Latch
Push
Battery
11
1. Connect the charger's power cord to a receptacle.
When the power cord is connected, the charger's
pilot lamp will blink in red. (At 1-second intervals)
WARNING:
Do not use the electrical cord if
damaged.
immediately.
2. Insert the battery into the charger.
Firmly insert the battery into the charger until the
line is visible, as shown in Fig. 4, 5.
Battery
Pilot lamp
Charger
Fig. 4
Line
Fig. 5
3. Charging
When the battery is connected to the battery charger,
charging will commence and the pilot lamp will light
in red. (See Table 2)
NOTE:
If the pilot lamp flikers in red, pull out the plug from
the receptacle and check if the battery is properly
mounted.
When the battery is fully charged, the pilot lamp will
blink in red slowly. (At 1-second intervals) (See Table
2)
10/2/12, 2:38 PM
English
Have it repaired
11