Mettler Toledo Q3 Manual De Usuario página 24

1 Using a tube cutter or a sharp knife, cut a sufficient
amount of tubing. The appropriate length mainly depends
on the distance between the bottle and the pump while
dosing.
Recommended length: about 0.7 m
2 Connect the air tube (1) to the air inlet of the bottle (2)
3 Insert the other end of the air tube (1) in a tube adapter
(3) and press firmly.
4 Connect the tube adapter (3) to one of the air outlets (4)
of the pump. Press until you hear a click.
When a tube is connected to the air outlet of the pump, the
valve of the air outlet opens. Never leave a tube that is
connected to the air outlet unconnected at the other end
because pressure cannot build up.
You can connect up to three bottles to each pump.
Connecting the muffler
Insert the muffler (1) into the air inlet (2) to absorb the
noise.
Removing the air tube
NOTICE
Damage to tube connectors due to mishandling
If the tubes are not removed correctly, the connectors of the pump and the bottle cap can be
damaged.
1 Remove the tube adapter (1) from the pump by pushing
the connector (2) of the air outlet towards the pump.
The adapter is released and can be removed.
16
To remove the tubes, press down the ring on the connector and pull out the tube carefully.
4
3
1
2
1
2
1
2
1
Q3 Dosing Module