Agilent TPS-mobile Instrucciones De Uso página 253

Technical Information
Table 9
Characteristic
Turbo Pump
TMP Flange
Forepump
Voltage
Base Pressure *
N Pumping Speed (L/s)
2
He Pumping Speed (L/s)
H Pumping Speed (L/s)
2
N Max gas flow rate (sccm)**
2
He Max gas flow rate (sccm)**
H Max gas flow rate (sccm)**
2
TMP Rotational Speed
Start-up time
Operating Position
Ambient Temperature
Bakeout Temperature
Protection Breaker
Installation category
Pollution Degree
Compliance with:
Indoor Use
Max altitude
Serial Communication kit
Storage Temperature
**
Note: values refer to air-cooled pump with:


Agilent TPS-mobile User Manual
TPS-mobile 115 V Technical Specification
measured in a leak-free test dome, 48 hours after the completion
ambient temperature 25 °C or below
backing pump with pumping speed equal or above 5 m
X3581-64500, X3581-64502, X3581-64504, X3581-64506,
X3581-64508, X3581-64510, X3581-64512, X3581-64514,
X3581-64516, X3581-64518, X3581-64520, X3581-64522,
X3581-64524, X3581-64526, X3581-64528, X3581-64530,
X3581-64532, X3581-64534
IDP-7, IDP-15, TS300, TS600, DS302, DS602
115 V / 50-60 Hz
< 1 x 10 -10
mbar (< 1 x 10
(according to standard DIN 28 428, the base pressure is that
of test dome bake-out, with a Turbopump fitted with a ConFlat
flange and using the recommended pre-vacuum pump)
60600 rpm (1010 Hz driving frequency)
< 3 minutes (it can be longer in case of soft start active)
On a flat floor
+5 °C to +35 °C
max 75 °C on Inlet Flange
EN 55011 (Class A Group 1), EN 61326-1, EN 61010-1,
EN 1012-2, EN 12100, RoHS: EN 63000
-20°C to +70°C
305 FSQ
ISO 100
-10
Torr)
250
255
220
375
450
450
14A
II
2
Only
2000 m
A-Plus
3 /h
253