Limits - DATATEC EDU34450A Guia Del Usuario

Limits

The Limit operation enables you to perform pass or fail testing to the upper and lower limits that you specify. The
upper limit value you select must be larger than the lower limit value. The initial factory settings for both values is
zero.
– This math operation applies to all measurement functions except continuity test.
– The instrument clears all limits after a Factory Reset (*RST command), an Instrument Preset (SYSTem:PRESet
command), or when a measurement function is changed.
Front Panel Operations
Press [Shift]> [Null] |Math> Function Limits> Limits ON | OFF.
The limit values and state is shown on the bottom of the display.
– PASS: The readings are within the specified limits.
– FAIL-HI: The reading is above the high limit.
– FAIL-LO: The reading is below the low limit.
Keysight EDU34450A User's Guide 73