Canopy Assembly; Blade Assembly; Switch Housing Assembly - Craftmade MND72BNK6 Guia De Instalacion

7. Canopy Assembly.

Locate 2 screws on underside of hanging bracket and
remove screw closest to the open end of the hanging
bracket. Partially loosen the other screw. Lift canopy to
hanging bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw that was
removed, and then tighten both screws securely. Slide
canopy cover up to canopy, aligning rounded part of
slotted holes in canopy cover with screw heads in
bottom of canopy. Turn cover to the right (clockwise)
until it stops.

8. Blade Assembly.

Time Saver: Washers for blade screws can be set on
each blade screw prior to installing blades.
Locate 24 blade attachment screws and washers in
hardware pack. Slide blade through one of the
narrow, rectangular openings on motor housing,
aligning holes in blade with holes in blade arm
(located on the underside of the motor
housing)--refer to drawing at right. [Be sure to note
label on blade indicating THIS SIDE UP.]
blade plate over holes in blade arm, making sure to
align all 4 holes, as shown in drawing at right.
Partially insert 4 blade attachment screws (along
with washers). Securely tighten screws with Phillips
screwdriver only after all 4 screws have been
inserted. Repeat procedure for remaining blades.
Note: Tighten blade arm screws twice a year.

9. Switch Housing Assembly.

Remove 3 screws from outer edge of switch housing
plate (save screws for later use).
Remove 1 screw from fitter plate on underside of
motor and partially loosen the other 2 screws. Align
slotted holes in center of switch housing plate with
loosened screws in fitter plate, allowing molex plugs
from motor housing to come through hole in middle
of switch housing plate. Twist switch housing plate to
lock. Re-insert screw that was removed and secure all
screws.
Align holes in switch housing cap with holes in switch
housing plate. Re-insert screws that were previously
removed and use a Phillips screwdriver to secure all
screws.
Then, place
page 7
screw
canopy cover
motor housing
hanging bracket
canopy
screw
blade
blade arm
blade plate
blade attachment
screws and washers
motor housing
fitter
plate
molex
plugs
switch housing
plate
switch
housing cap