Wiring; Canopy Assembly - Craftmade ELLINGTON E-PLD56ABZ5CWR Guia De Instalacion

6. Wiring.

CAUTION: Be sure outlet box is properly grounded and that a
ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with Local Codes
or Ordinances and the National Electrical Code. If you are
unfamiliar with electrical wiring or if the house/building wires
are different colors than those referred to in the diagram to the
right, please use a qualified electrician.
When downrod is secured in place on the hanging bracket,
electrical wiring can be
made as follows:
Connect BLACK wire from fan to BLACK wire from ceiling
with wire connector provided.
Connect WHITE wire from fan to WHITE wire from ceiling
with wire connector provided.
Connect all GROUND (GREEN) wires together from fan to
BARE/GREEN wire from ceiling with wire connector
provided.
* Wrap each wire connector separately with electrical tape
as an extra safety measure safety.
IN ORDER TO WIRE WALL CONTROL, remove existing wall
switch. Wire the WALL CONTROL with wire connectors
provided as shown in diagram at right.
* Wrap each wire connector separately with electrical tape
as an extra safety measure. Gently push taped wire
connectors into outlet box.
Use a ballpoint pen or a small screwdriver to set the code
switches 1 through 4 on the wall control. Factory setting is
pre-set and not recommended for use.
Note: Since this fan comes with candelabra base bulbs, the
dimmer switch (labeled D and X) has been pre-set to the
"ON" position (D). If you do not wish to have dimming
capability, please move the switch to the "OFF" position (X).
Attach wall control to outlet box and secure with screws
from original wall switch. Attach front plate to wall control
using 2 screws provided in the wall control.

7. Canopy Assembly.

Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen the
other screw. Lift canopy to hanging bracket.
Place rounded part of slotted hole in canopy
over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw
that was removed, and then tighten both screws
securely.
All manuals and user guides at all-guides.com
page 6
from ceiling
from fan
outlet box
green/ green/ green/
bare bare
bare
ground ground ground
black
black
(AC IN from
breaker box)
ground
(green or bare)
wall
control
plate
code
switches
green
black (OUT to fan)
black
(TO POWER supply)
hanging bracket
canopy
screw