Wiring; Canopy Assembly - Craftmade Yorktown Guia De Instalacion

6. Wiring.

CAUTION: Be sure outlet box is properly grounded
and that a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with electrical
wiring or if the house/building wires are different
colors than those referred to below, please use a
qualified electrician.
Note: Excess lead wire length from the fan can be
cut to the desired length and then stripped.
When downrod is secured in place on the hanging
bracket, electrical wiring can be made as follows:
Connect BLACK wire from fan to BLACK wire from
ceiling with wire connector provided.
Connect WHITE wire from fan to WHITE wire from
ceiling with wire connector provided.
Connect all GROUND (GREEN) wires together
from fan to BARE/GREEN wire from ceiling with
wire connector provided.
Since this fan does not come with a light kit, you
will need to cap off the BLUE wire with a wire
connector (as shown with arrow in diagram).
[Note: If you elect to purchase a light kit for the
fan, the BLUE wire from the fan must be
connected to the BLACK (or RED) wire from the
ceiling instead.]
*Wrap each wire connector separately with
electrical tape as an extra safety measure.
This fan is remote control adaptable (remote control
sold separately).

7. Canopy Assembly.

Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded part
of slotted hole in canopy over loosened screw in
hanging bracket and push up. Twist canopy to lock.
Re-insert screw that was previously removed and
then tighten both screws securely.
Slide canopy cover up to canopy, aligning rounded
part of slotted holes in canopy cover with screw
heads in bottom of canopy. Turn canopy cover to
the right (clockwise) until it stops.
white supply wire
black supply wire
from
ceiling
black
white
white
black
blue
from fan
canopy
screw
page 6
ground
(green or bare)
wire
connector
ground
(green
or bare)
*
hanging bracket
screw
canopy cover