Sawing With Special Base Runners; Sawing With The Angle Table; Sawing With The Adaptation Table - Festool CARVEX PS 400 EBQ Manual De Instrucciones Original/Lista De Piezas De Repuesto

CARVEX
GB
10.2 Sawing with special base run-
ners
The special base runners protect high-quality
surfaces against scratches and scores.
X
Press in the base runner at position [6-1].
X
At the same time, push the base runner
forwards.
X
Mount another base runner and push it to
the rear until it engages.
10.3

Sawing with the angle table

The angle table WT-PS 400 is used for sawing
interior and exterior angles up to 45° and
pipes.
Dust extraction is not possible when
sawing with the angle table!
Installing the angle table
X Remove the saw table [1-11], (see chap-
ter 7.4).
X Position the angle table against the saw
table support.
X
Close the change lever [1-9].
Ensure that the angle table is firmly seated in
the guide.
Setting the angle
X Turn the adjusting wheel
desired angle.
At the scale [7-2], you can set the values -
45°, 0° and +45°.
Angle table
position
Picture [7A] Angle, interior angle
Picture [7B] Angle
Picture [7C] Exterior angle, pipes
WARNING
Sawing cutting depths
Risk of injury
X Select the saw blade length and cutting
depth so that the saw blade always stays
in the workpiece.
L For 90° cuts, we recommend setting the
angle table to a small negative degree
value to guarantee stable running.
18
[7-1] to set the
Application
10.4 Sawing with the adaptation ta-
ble
The adaptation table ADT-PS 400 is used for
attaching your jigsaw to the Festool guide
rail, the circle cutter KS-PS 400 and the CMS
modular system.
Installing the adaptation table
X
Remove the saw table [1-11], (see chap-
ter 7.4).
X
Mount the adaptation table
saw table support.
X
Close the change lever [1-9].
Ensure that the adaptation table is firmly
seated in the guide.
L Use the extractor connector
with the adaptation table.
Adaptation to the guide rail FS
The use of the Festool guide system FS (Pic-
ture [9]) makes it easier to produce straight
and precise cuts, in particular, with material
thicknesses up to 20 mm.
X
Mount the jigsaw with installed adaptation
table [8-1] on the guide rail.
Adaptation to the circle cutter
The circle cutter can be used to create circu-
lar cuts with a diameter between 120 and
3000 mm. The circle cutter can be installed
from both sides on the adaptation table.
X
Mount the jigsaw with adaptation table on
the adapter [10-1]
X
Insert the centring mandrel
bore [10-4] of the circle cutter, which is
aligned with the saw blade.
X
Clamp the measuring tape at the circle
cutter with the rotary knob [10-5].
L Store the centring mandrel in the depot
[10-3].
Semi-stationary sawing with the Festool
CMS system
When combined with the Festool CMS sys-
tem, the jigsaw becomes a semi-stationary
bench saw for profiled cuts. See the CMS
brochure for more information.
X
Install your jigsaw with adaptation table
in the CMS as described in the operating
manual for the CMS-PS.
[8-1] on the
[1-8] also
at the circle cutter.
[10-2] in the